A1 mini 0.2mm nozzle calibration issues
Hello all. I am reaching out and writing here because I am having some issues after I've switched from 0.4mm to 0.2mm nozzle and I cannot troubleshoot the problem myself, I'm just not experienced enough in the realm of 3D printing.
I've never really had major issues printing anything with the 0.4mm nozzle after doing calibration, but unfortunatelly the 0.2mm nozzle is giving me a headache. I've tried a bunch of different settings (filament and printer) to resolve the issue but nothing seems to work and I think I've only made the issue worse.
It is a combination of issues, really. On some prints the bed adhesion is rubbish and the supports break and spaghetti. Sometimes its overextrusion, sometimes its underextrusion, both to the same end - spaghetti.
I'm uploading the results from the latest flow rate calibration.
Hello all. I am reaching out and writing here because I am having some issues after I've switched from 0.4mm to 0.2mm nozzle and I cannot troubleshoot the problem myself, I'm just not experienced enough in the realm of 3D printing.
I've never really had major issues printing anything with the 0.4mm nozzle after doing calibration, but unfortunatelly the 0.2mm nozzle is giving me a headache. I've tried a bunch of different settings (filament and printer) to resolve the issue but nothing seems to work and I think I've only made the issue worse.
It is a combination of issues, really. On some prints the bed adhesion is rubbish and the supports break and spaghetti. Sometimes its overextrusion, sometimes its underextrusion, both to the same end - spaghetti.
I'm uploading the results from the latest flow rate calibration.